Milwaukee Big Hawg Carbide-Teeth Hole Saw Kit 49-56-9290 (10-Piece) Review (2026)
By Nate Sawyer, Editor · Updated July 2026
DIYPicks is reader-supported. As an Amazon Associate and affiliate of home-improvement retailers, we may earn a commission when you buy through links on our site — at no extra cost to you. This never affects our recommendations.
- Large holes
- Nail embedded wood
- Abrasive material
A 10-piece carbide-tooth hole saw kit (6 saws, 2-1/8-4-1/4 in.) for holes up to 5x faster than bi-metal, and through nail-embedded wood, cement board, and shingles that strip bi-metal teeth. The thin-wall design plunges fast. It's pricey and limited to six sizes, the carbide chips if you pry sideways, and it's overkill in plain lumber.
Pros
- Large carbide teeth rip large-diameter holes up to 5x faster than a bi-metal saw
- Cuts nail-embedded wood, cement board, plaster and shingles that would strip bi-metal teeth
- Shallow thin-wall design plunges quickly and clears plugs more easily than a deep bi-metal cup
Cons
- Expensive and limited to six larger sizes - no small-diameter or fine-hole options
- Carbide teeth chip if you pry sideways or drop the saw on concrete
- Overkill and pricey for clean holes in plain lumber or drywall where bi-metal is enough
Specifications
| Material | Carbide teeth on steel body |
|---|---|
| Sizes | 2-1/8 - 4-1/4 in (6 saws) |
| Shank | Big Hawg arbor + pilot bits |
| Teeth | Large carbide teeth, thin kerf |
| Best for | Fast large holes, tough material |