Loctite Epoxy Five Minute Instant Mix Review (2026)
By Nate Sawyer, Editor · Updated July 2026
DIYPicks is reader-supported. As an Amazon Associate and affiliate of home-improvement retailers, we may earn a commission when you buy through links on our site — at no extra cost to you. This never affects our recommendations.
- Metal
- Plastic
- Ceramic
- Wood
- Gap filling
A convenient no-mess epoxy whose self-mixing syringe makes it beginner-friendly for fast repairs on metal, plastic and ceramic, though the yellowish cure and modest strength keep it out of heavy structural territory.
Pros
- The self-mixing nozzle dispenses pre-blended epoxy, so no hand-mixing or guesswork
- Fast 5-minute set with handling strength in about an hour
- Good impact and solvent resistance for a fast general-purpose epoxy
Cons
- Cures a translucent yellow rather than truly clear, so it can show on light surfaces
- Self-mixing nozzle can clog or waste product if you stop and start
- Not rated for the extreme heat or continuous water immersion a metal-repair epoxy handles
Specifications
| Type | Two-part epoxy with self-mixing nozzle (0.47 fl oz dual syringe) |
|---|---|
| Cure | Sets ~5 min, handling strength ~1 hr, full cure ~24 hr |
| Waterproof | Resists humidity and water; not for continuous immersion |
| Paintable | Yes, after full cure |
| Use | Adhesive or filler for metal, wood, ceramic, tile and glass |
| Cleanup | Acetone for uncured; cured epoxy must be removed mechanically |
Frequently Asked Questions
- What does the self-mixing nozzle change?
- It dispenses pre-blended epoxy, so there is no hand-mixing and no ratio guesswork — the most common cause of a weak epoxy bond disappears. The trade-off is waste: the nozzle can clog or waste product if you stop and start.
- Does Loctite 5-minute epoxy dry clear?
- Not truly clear — it cures a translucent yellow, so it can show on light or transparent surfaces. If invisibility matters, a crystal-clear epoxy is the better pick.
- Is it suitable for high heat or submerged parts?
- No. It resists humidity and splashes but is not rated for continuous immersion, and it does not handle the extreme heat a dedicated metal-repair epoxy takes. Handling strength comes at about an hour, full cure at 24.