Diablo D1060X 10 in. 60-Tooth Fine Finish Saw Blade Review (2026)
By Nate Sawyer, Editor · Updated July 2026
DIYPicks is reader-supported. As an Amazon Associate and affiliate of home-improvement retailers, we may earn a commission when you buy through links on our site — at no extra cost to you. This never affects our recommendations.
- Crosscut
- Trim molding
- Plywood
- General finish
The Diablo D1060X is a 10 in, 60-tooth Hi-ATB fine-finish blade that hits the sweet spot for miter saws: cleaner and more versatile than a 40T, faster than an 80T. TiCo Hi-Density carbide, a 15-degree hook and stabilizer vents deliver smooth, low-vibration crosscuts in trim, molding, hardwood and plywood, and it can handle light rips on a table saw too. It is the all-round finish choice, with the 80T reserved for the most demanding visible cuts.
Pros
- 60T Hi-ATB grind leaves a near-sanded crosscut while cutting faster than an 80T
- Handles crosscuts and light rips, so it works on both miter and table saws
- Stabilizer vents cut noise and vibration for a cleaner, quieter cut
Cons
- Not quite as glass-smooth as an 80T blade on the finest trim
- Still too many teeth for fast ripping of thick stock
- Can burn if fed too slowly in dense hardwood
Specifications
| Teeth | 60T Hi-ATB |
|---|---|
| Diameter | 10 in |
| Arbor | 5/8 in |
| Kerf | 0.098 in |
| Hook angle | 15 deg |
| Material | TiCo Hi-Density carbide |
| Best for | Smooth crosscuts on trim, hardwood and plywood |
Frequently Asked Questions
- Is 60 teeth the right count for a miter saw?
- For most people, yes. A 60T Hi-ATB grind leaves a near-sanded crosscut while cutting faster than an 80T, which makes it the practical middle ground for trim, hardwood and plywood.
- Can this blade go on a table saw too?
- Yes — it handles crosscuts and light rips, so it works on both miter and table saws. It is still too many teeth for fast ripping of thick stock, where the cut slows and heat builds.
- Why does the blade burn the wood?
- Usually because it is fed too slowly in dense hardwood — the teeth rub instead of cutting. Keep a steady feed. The stabilizer vents help by cutting noise and vibration, which also improves cut quality.