DeWalt DWA4216 Universal-Fit Oscillating Multi-Tool Blade Set (5-Piece) Review (2026)
By Nate Sawyer, Editor · Updated July 2026
DIYPicks is reader-supported. As an Amazon Associate and affiliate of home-improvement retailers, we may earn a commission when you buy through links on our site — at no extra cost to you. This never affects our recommendations.
- Flush cut
- Wood with nails
- Remodeling
A 5-piece universal-fit oscillating multi-tool set (bi-metal wood and wood+nails blades, a titanium flush-cut blade, and a scraper) that mounts on Fein, Bosch, Makita, and most tools with no adapter. It suits flush cuts, plunge cuts, and remodeling detail. Cost per blade runs high, oscillating cutting is slow, and the edges wear fast on nails.
Pros
- Universal arbor mounts on Fein, Bosch, Makita and most other multi-tools without an adapter
- Includes bi-metal wood-with-nails blades that survive the occasional embedded fastener
- Titanium flush-cut blade trims door jambs and proud plugs right at the surface
Cons
- Higher cost per blade than single-material oscillating blades
- Oscillating cutting is slow, so it is a detail tool, not a demolition tool
- Bi-metal edges wear quickly if pushed hard into repeated nail contact
Specifications
| TPI | Mixed (wood, wood+nails, scraper) |
|---|---|
| Length | Assorted |
| Material | Bi-metal + titanium flush blade |
| Shank | Universal fit (no adapter) |
| Best cut | Flush / plunge in wood, drywall, light metal |
Frequently Asked Questions
- Will these oscillating blades fit my multi-tool?
- Almost certainly — the universal arbor mounts on Fein, Bosch, Makita and most other multi-tools without an adapter, which is the main friction point when buying oscillating blades.
- Can these blades cut through nails?
- The bi-metal wood-with-nails blades survive the occasional embedded fastener, which is what makes them useful in remodeling. Repeated nail contact still wears the edges quickly, so treat it as tolerance rather than a design purpose.
- Is an oscillating tool a substitute for a saw?
- No. Oscillating cutting is slow — it is a detail and flush-cut tool, not a demolition tool. The titanium flush blade is the standout here, trimming door jambs and proud plugs right at the surface where no other saw reaches.