DeWalt 2-1/2 in. 16-Gauge Straight Finish Nails (DCS16250) Review (2026)
By Nate Sawyer, Editor · Updated July 2026
DIYPicks is reader-supported. As an Amazon Associate and affiliate of home-improvement retailers, we may earn a commission when you buy through links on our site — at no extra cost to you. This never affects our recommendations.
- Baseboard
- Casing
- Crown molding
DeWalt's DCS16250 is a 2-1/2 in, 16-gauge straight finish nail for interior baseboard, casing and crown that must stay put, giving more grip than an 18ga brad with a fillable hole. The 2,500-count box is strong value. But straight-magazine guns can't reach tight inside corners, the bright finish is interior-only, and it fills more than a brad.
Pros
- 16-gauge holds noticeably better than an 18ga brad, right for baseboard, casing and crown that must stay put
- 2,500-count box at about $46 is strong value, roughly 1.8 cents per nail for consistent DeWalt QC
- Uniform collation feeds cleanly with very few jams across DeWalt and compatible 16ga straight nailers
Cons
- Straight-magazine 16ga nailers are bulkier and can't reach tight inside corners an angled gun handles
- Bright finish is interior only and will corrode if used outdoors or against pressure-treated wood
- Bigger hole than an 18ga brad means more filling and sanding on show surfaces
Specifications
| Gauge | 16-gauge |
|---|---|
| Length range | 1 - 2-1/2 in (line); 2-1/2 in this SKU |
| Collation | Straight strip (plastic collated) |
| Coating | Bright / galvanized |
| Best for | Baseboard & casing |