Bosch Bulldog Xtreme SDS-Plus Carbide Masonry Bit Set (7-Piece) Review (2026)
By Nate Sawyer, Editor · Updated July 2026
DIYPicks is reader-supported. As an Amazon Associate and affiliate of home-improvement retailers, we may earn a commission when you buy through links on our site — at no extra cost to you. This never affects our recommendations.
- Masonry
- Concrete
- Brick
A 7-piece SDS-plus carbide masonry bit set (3/16-1/2 in.) for drilling anchor holes in concrete, block, and brick with a rotary hammer. The full-head carbide tip survives rebar strikes that chip 2-cutter bits, and the flute clears dust to cut fast. It needs an SDS-plus hammer, is overkill for soft brick, and longer bits can wander at the start.
Pros
- Full-head carbide tip survives rebar strikes that chip standard 2-cutter masonry bits
- SDS-plus shank locks into a rotary hammer for hammering force no keyless chuck can match
- Variable flute clears dust aggressively, cutting faster and reducing bit-jamming heat
Cons
- Requires an SDS-plus rotary hammer - these will not fit a standard keyed/keyless drill chuck
- Overkill (and awkward) for soft brick or a single small anchor hole
- Longer bits can wander at the start until the centering tip bites
Specifications
| Material | Carbide-tipped alloy steel |
|---|---|
| Sizes | 3/16 - 1/2 in x 4-12 in lengths |
| Shank | SDS-plus (rotary hammer) |
| Point | Full-head carbide, centering tip |
| Best for | Concrete, block, brick anchoring holes |
Frequently Asked Questions
- Will Bulldog Xtreme bits fit a regular drill?
- No. These are SDS-plus shank bits for a rotary hammer and will not fit a standard keyed or keyless chuck. That is the first thing to confirm before buying the set.
- What happens if you hit rebar?
- The full-head carbide tip is designed to survive rebar strikes that chip standard two-cutter masonry bits. That durability is the main reason to pay for this set over a budget alternative.
- Is this set overkill for a few anchor holes?
- For soft brick or a single small anchor, yes — it is both overkill and awkward. It earns its place when you are drilling concrete or block repeatedly. Longer bits can also wander at the start until the centering tip bites.